Eldes EPIR2, Manual

Page: 29 / 64

29 29
EPIR2 User Manual v.1.4
1. Arm the system in Stay mode manually by entering the following combination using [STAY]
and number keys:
Press the [STAY] key & enter user password:
STAY uuuu
Value: uuuu - 4-digit user password
Example: STAY1111
2. After the system is successfully armed, it will reply with confirmation by SMS message to User
1 phone number (by default).
SMS
User
EPIR2
54
For more details on how to disarm & turn off the alarm by EKB3W keypad, please refer to section 2.3.4.
2.3.6. Alarm indications & how to view violated zones / tampers by EKB3W
The built-in EKB3W mini-buzzer provide short beeps continuously in case of alarm. In addition, the
violated zone number is indicated by illuminated zone LED or flashing SYSTEM LED (if the violated
zone number is above 12). The violated tamper number is indicated by flashing zone LED or illu-
minated SYSTEM LED (if the violated tamper number is above 12). In both cases. the mini-buzzer
can be silenced by disarming the system using any method.
For more details on EKB3W violated high-number zone & tamper number indication, please refer
to section 2.3.8. Fault messages .
2.3.7. How to bypass a violated zone & activate a bypassed zone by EKB3W
Arming the system is disabled while there’s at least 1 violated zone. Bypassing the zone allows to
temporally disable a particular violated zone and arm the alarm system afterwards.
Bypass a violated zone by entering the following combination using [BYPS], number and [#] keys:
Press the [BYPS] key, enter zone number & user password:
BYPS nn uuuu#
Value: nn – zone number, range – [01... 34]; uuuu – 4-digit user password
Example: BYPS051111#
To activate a bypassed zone, enter the same combination again.
NOTE: The alternative way to activate all bypassed zones at once is to disarm the system.
NOTE: Zones can only be bypassed when the system is not armed.