/ 22 /
STEP 1
The Kit X comes with Reservoir EK-RES X3 150 which has en-
closed mounting clamps.
Your reservoirs outlet port, which is usually directed to-
wards the pumps inlet port should be installed in same
level or higher than the pump in order to allow easy
priming.
You can turn your reservoir in any direction as long as
the outlet port is always fl ooded.
STEP 2
Look for the suitable position in your PC chassis. The two clamps
must hold the reservoir tube so be careful that you install them
from 15mm to 60mm apart as shown on the picture on the right.
Alternatively you can drill two Ø4,5mm holes using
electric power drill to the most suitable place on the wall
of your computer chassis.
Take the two M4x12 screws and guide them through the central
clamp holes and the holes on the chassis.
STEP 3
Secure the M4x12 screws from the previous step with two M4
nuts and PVC washers. Tighten them using Phillips screwdriver
with the screws.
Make sure that the screws are holding tight but do not
exaggerate with the force applied.
STEP 1
RES X3 Mounting
Clamps
M4x12 screw
Reservoir RES X3
STEP 2
STEP 3
PC Chassis
M4x12
screw
INSTALLING THE RESERVOIR
RES X3 mounting clamp
PVC washer
M4 nut
PC Chassis
15 - 6
0 m
m