/ 25 /
STEP5
STEP3
STEP4
Fitting Ring
Fitting Ring
STEP 3
If you have assembled the components according
to this installation manual you should have all the
compression fittings installed.
In order to install the tubing onto the compression fittings you
will have to remove the fitting ring by screwing it in counter-
clockwise direction.
STEP 4
Slide the fitting ring along the tube with the threaded side fac-
ing the fitting barb.
Install the tube on fitting barb. If needed heat the tube in warm
water (40-50°C). You can do that by forcing it to slide over
the edge as far as it goes.
STEP 5.:
Slide the fitting ring towards the barb and tighten it in clock-
wise direction as far as it goes.
Repeat the procedure on all the fittings in order to connect the
water cooling loop.
Tubing
