/ 20 /
STEP 3
Secure the M4x6 screws (from the previous step) with four M4 nuts and PVC
washers. Tighten them using 2,5mm Allen key with the screws.
Make sure that the screws are holding tight but do not exaggerate
with the force applied.
STEP 4
This unit can be installed anywhere where there is a 50x50mm square
mounting hole pattern on the chassis without using any pump bracket.
Tighten the fi tting barbs in clockwise direction until the gasket underneath is
compressed.
The installation of the pump unit is now complete.
OPTION 2:
INSTALLING THE PUMP ON THE CHAS-
SIS WALL
STEP 1
The KIT comes with pump unit with pre-installed anti-vibration decouplers.
Take the unit and place it on the EK-UNI Pump Bracket (120mm Fan) Vertical,
as shown on the picture.
Turn your pump in any direction, as long it is not turned upside-down.
Secure it from the bottom side using four M4x4 screws and PVC washers.
Tighten them in clockwise direction using enclosed 2,5mm Allen key.
This unit can be installed anywhere where there is 50x50mm square
mounting hole pattern of the chassis.
STEP 3
STEP 4
PVC washer
M4 nut
PC Chassis
Fitting Barb
Fitting Ring
STEP 1
Pump unit
120mm fan UNI
pump bracket
PVC washer
M4x4 screw