300631 • 1/2018 • H.S.
62 of 82
9 T
roubleshooting
Installation and Operating Instructions
High Pressure Cleaner, Hot Water, Stationary
HSC1140-INOX Gas
9
Troubleshooting
WARNING
Carry out troubleshooting and rectification properly.
Troubleshooting of the system may only be carried out by trained and
qualified personnel.
Before troubleshooting inside the system, take the system out of
operation and disconnect it from the electrical supply of the building.
For troubleshooting and repair of the gas burner, depending on system
configuration observe the installation and operating instructions of
Weishaupt (gas burner WG5) or Baltur (gas burner BPM90).
9.1
Troubleshooting table
The following table lists possible causes of failures.
Clean the contaminated parts (filter, high pressure nozzle etc.) to eliminate
the fault. Replace defective parts. Information on this can be found in
section 9.2 (Replacing components and Parts).
