300631 • 1/2018 • H.S.
15 of 82
2 Safety
Installation and Operating Instructions
High Pressure Cleaner, Hot Water, Stationary
HSC1140-INOX Gas
●
The installation of the gas pipes, as well as the gas-side connection of
the system, may only be carried out by a specialist company approved in
the gas and water trade.
●
Only the gas supplier or a contracted installer may carry out adjustment,
maintenance or repair work on gas installations in buildings and
premises.
●
Line systems must be subjected to a load and leak test or a serviceability
test in accordance with the operating pressure (e.g. DVGW-TRGI,
Worksheet G 600).
●
Depending on the type and quality of the gas, gas supply must
be carried out in such a way that no liquid substances are formed
(e.g. condensate). For liquid gas, observe evaporation pressure and
evaporation temperature.
●
When planning a chimney, the locally valid guidelines must be observed
●
Only use tested sealing materials and observe the processing
instructions.
●
When switching to a different type of gas, reset the condensing boiler
system. The changeover between liquid and natural gas requires a
conversion.
●
Carry out leak test after every maintenance and troubleshooting.
2.5
Accident prevention regulations
Observe the applicable national regulations of the legislator on accident
prevention.
2.6
Lifting and moving loads
The High Pressure Cleaner, Hot Water, Stationary, HSC1140-INOX Gas
weighs 300 kg (with packaging 317 kg).
Lifting and moving loads is permitted for one person up to 23 kg. If the
load exceeds 23 kg (e.g. system units, assemblies) use suitable lifting
equipment (e.g. forklift, lift trucks).
Observe the international standard „ISO 11228-1 Ergonomie - Manuelles
Handhaben von Lasten - Teil 1 Heben und Tragen 05/2003“.
2.7
Periodic inspections
The periodic inspections are listed in Section 8 (Maintenance).
