300631 • 1/2018 • H.S.
51 of 82
6 Operation
Installation and Operating Instructions
High Pressure Cleaner, Hot Water, Stationary
HSC1140-INOX Gas
!
Fig. 6 - 5
Recoil force when switching on the trigger gun
Unlock and pull the trigger lever (3, Fig. 6-2) of the trigger gun.
Set the main switch Start - Stop (1, fig. 6 - 1) on the front of the cabinet
door to position I. The high pressure cleaner starts. The pump first
delivers air from the high pressure nozzle. After a short time, water
then escapes.
If the trigger lever on the trigger gun is released, the high pressure
cleaner switches to pressureless bypass operation. After 5-160 sec.
(adjustable) bypass mode switches the system to stand-by mode. When
the lever on the trigger gun is pulled again, the motor and the pump
restart automatically.
General Information
If the system remains in stand-by mode for 20 minutes, the electronic
control switches the high pressure cleaner off as programmed.
To resume operation, set the main switch Start - Stop to position 0 and
then back to operating position I.
WARNING
Risk of scalding due to hot water.
The hot water escaping from the high pressure jet must not come into
contact with persons. Otherwise scalding may occur in persons.
On the front of the cabinet door, the two main switches listed below
can be used to switch on/off
○
Hot water (2, Fig. 6 - 1):
The heated water comes out of the high pressure nozzle at a
temperature preset by the system operator.
