300631 • 1/2018 • H.S.
50 of 82
6 Operation
Installation and Operating Instructions
High Pressure Cleaner, Hot Water, Stationary
HSC1140-INOX Gas
General Information
If the system remains in stand-by mode for 20 minutes, the electronic
control switches the high pressure cleaner off as programmed.
To resume operation, set the Start-Stop main switch to position 0 and
then back to operating position I.
Inside the cabinet, the detergent control valve (4, Fig. 6 - 3) can be set
to add a desired quantity of detergent to the high pressure jet. Observe
section 6.4 (Use of cleaning agents, chemicals).
The cleaning agent admixture can be switched on/off (switch positions 0/I)
at the main switch Detergent on the cabinet door front.
The cabinet door must be closed during cleaning work.
For safety reasons after completion of cleaning work
○
Lock the trigger lever of the trigger gun against unintentional
switching on using the locking lever (4, Fig. 6-2). Ensure that the
locking lever is positioned in the notch for the locking lever (5, Fig.
6-2).
○
Switch off the system via the main Start - Stop switch on the cabinet
door front (set switch to position 0).
6.3.3
System operation for operating personnel
General Information
Operation of the system by operating personnel is limited to switching
on/off the three main switches on the front of the cabinet door.
For cleaning operation by the operating personnel, proceed as follows:
If necessary, open the shut-off valve of the tap water network.
WARNING
Before activating, hold the trigger gun and the spray lance tightly.
After activation of the trigger gun the emerging water jet exerts a jerky
recoil force (see also Fig. 6 - 5).
This may result in unintentional jerking away from the selected cleaning
object or the trigger gun slipping out of the hand, endangering the life
and limb of persons.
