Efka DA320G5351, Connection Diagrams

Page: 27 / 38

EFKA DA320G5351
29
Supplier Level
Code no. 311 with control operation
Code no. 3112 with control panel operation
Parameter Designation Unit Limits Preset for Ind.
max min 100
Ω
220
Ω
680
Ω
1000
Ω
262 hPt 0 = Roller remains lowered when enabling 1 0 0 0 1 0 A
high lift for walking foot.
1 = Roller is lifted when enabling high lift for
walking foot.
Effective only if parameter 250 = 11 and
parameter 255 = 5 or if parameter 250 = 5 and
parameter 255 = 11.
263 ihr Handwheel increments carried out when incr. 500 0 10 10 10 10 A
the key is pressed once (function module
A at the input of socket A/8 or function
module B at the input of socket A/7)
264 nhr Handwheel speed RPM 150 30 50 50 50 50 A**)
265 dhr Delay time until the key is pressed down ms 2550 0 200 200 200 200 A**)
causing the handwheel to rotate
continuously (function module A at the
input of socket A/8 or function module B
at the input of socket A/7).
Pressing the key briefly : if ≤ preset value
of parameter 262. Increments set using
parameter 260 are carried out.
Keeping the key pressed down : if ≥
preset value of parameter 262. Handwheel
rotates continuously.
266 LFL 0 = Sewing foot lowers when the handwheel 1 0 1 1 1 1 A
rotates.
1 = The functions “pedal in pos. –1” or “automatic
sewing foot lift” remain effective
267 kFk 0 = The edge trimmer remains On, independently 1 0 0 0 0 0 A
of sewing foot lifting.
1 = The edge trimmer is disabled when the
sewing foot is lifted
269 PSv Positioning shift degrees 100 0 15 15 15 15 A
270 PGm Selection according to the position sensors. 5 0 0 0 0 0 A
Setting of socket B18 see chapter “Connection
Diagram”
0 = The positions are generated by means of the
transmitter incorporated in the motor and can
be set using parameter 171.
1 = Setting the sensor to position 2.
Set position 1 using parameter 171, starting
from leading edge position 2.
2 = Setting the sensor to position 2.
Set position 1 using parameter 171, starting
from trailing edge position 2.
3 = Setting the sensor to position 1.
Set position 2 using parameter 171, starting
from leading edge position 1.
4 = Setting the sensor to position 1.
Set position 2 using parameter 171, starting
from trailing edge position 1.
5 = No position sensor available. The drive stops
unpositioned. The thread trimmer function is
suppressed with this setting.
**) When programming the 3-digit or 4-digit control parameter values (without control panel), the 2-digit or 3-digit
value displayed must be multiplied by 10.