EFI E-85A, Installation And Service Manual

Page: 102 / 143

102 Installation and Service Guide: Color Controller E-85A
Installing System Software
8
After copying the System Software DVD 3 contents to the hard drive (approximately eight minutes), when prompted,
eject the DVD and insert the User Software DVD 4.
When the contents of the User Software DVD 4 are copied to the hard disk (approximately eight minutes after), eject
the User Software DVD 4. The E-85A reboots to begin the software installation.
9
If at step 4 , you select the installation of Fiery Color Profiler Suite, you will be prompted to insert each of these DVDs.
Time required to install Fiery Color Profiler Suite is approximately five minutes.
After the last DVD is ejected, the installation process continues for another thirty minutes.
The following steps are for use with the monitor, keyboard, and mouse. If you are not using this interface kit, skip to
step 12 .
10
At the Admin login, enter the password and then press
Enter
.
Fiery.1
is the default password and is case-sensitive.
11
Follow the on-screen instructions in the Fiery Setup Wizard to configure the E-85A for the customer’s print
environment.
Once you have completed configuring the Fiery Setup Wizard, you must restart the server for the changes to take effect.
If desired, you can print a Server Configuration Sheet after the restart.
For more information about the Fiery Setup Wizard, see Configuration and Setup , which is part of the user
documentation.
12
Wait for the Command WorkStation to start.
During the installation, a localhost connection to Command Workstation is created so when you start the E-85A,
Command WorkStation starts also.
13
Install and activate Fiery Impose and Fiery Compose.
Note:
If Fiery Impose and Compose are activated, you must deactivate them before you reinstall.
For more information, see the installation document that accompanies the Fiery Impose-Compose kit (Installing the
Fiery Option).
14
Shut down the E-85A (see page 40 ).
After installing or updating the system software
1
Restore the dongles and devices that you removed in a previous step.
2
Start the E-85A (see page 24 ).
3
Install any required software patches (see page 104 ).