Effekta AX M2 Series, User Manual

Page: 56 / 132

Innovating power.
AX M2 Series 3-5 kW | Solar inverter
7 Storage, Transport and Unpacking
7.1 Storage
If the solar inverter is to be stored after delivery, the following points must be
observed:
▪
Always leave the device and the accessories in the original packaging.
▪
The recommended room temperature should be within the range of 10 – 25 °
C. In each case, it should not exceed or drop below the maximum temperature
limits.
▪ The delivery must also be protected against moisture. It should only be stored
under dry conditions.
▪
If the storage period exceeds 4 months, the accumulators of the solar inverter must
be charged for a period of ca. 24 hours to avoid a deep discharge of the
accumulators and, by implication, irreversible damage to these.
7.2 Transport to installation site
The solar inverter is only permitted to be transported to the point of
destination in its original packaging. The same applies to moves or return
shipments.
The packaging does not have functional impact protection. As a result, all
devices that fall or tip over before their initial operation must be inspected by
EFFEKTA Regeltechnik GmbH. The same applies to damages to the devices.
In general, there is a high risk in the case of transport damages that the energy
storage system and/or its electrical connections are also affected. This does
not exclude short circuits and/or electrolyte leakage. This is why the unit must
be isolated until inspection.
Because the delivery usually does not coincide with the installation site, the
system must be transported there. In doing so, the following must be
observed:
Always transport the original delivery as close as possible to the installation
site. After unpacking and positioning the system, this should be moved to the
final installation site by means of a lift truck or transport rolls;
Always transport the system to the predetermined transport position.
Also mind the indicated center of gravity when transporting.
These is always a general risk of tipping in units with a high center of gravity.
Solar inverter | V1.7
Storage, Transport and Unpacking – Page 56