Edirol PCR-M30, Owner'S Manual

Page: 72 / 124

72
Use MIDI functionality
SYS EX. ASSIGN
Here’s how you can assign a system exclusive message to a controller. Advanced mode 2 lets
you assign a single-byte system message (System realtime message, tune request).
Advanced modes 3 and 4 let you assign any desired message.(Input up to 24 bytes)
SYS EX. ASSIGN can calculate the checksum automatically, and lets you specify a variable
(data) range or embed a channel/block number within the message.
(
➔
“Sys Ex. ASSIGN items” (p. 74))
In SYS EX. ASSIGN, the input mode will be HEX mode (p. 49).
fig.edt
1
Press the [EDIT] button.
The display will indicate “EDT.”
fig.r-1
2
Slightly move the controller to which you want to assign the system
exclusive message. In the case of a button, press that button.
The display will indicate the number of the selected controller.
3
Confirm what’s indicated, and press the
[ENTER]
button.
fig.se0
4
Press the
[SYSTEM Ex.]
key.
5
If you want to select an Advanced mode, press a key from [1] to [4] .
The selected mode will blink in the display.
6
Confirm what’s indicated, and press the [ENTER] button.
Then continue with the procedure described in Basic mode or Advanced mode.
For some actual examples of settings, refer to
“Examples of assigning system exclusive
messages”
(p. 77).
Mode number
Key-
board
Mode Value range
Required
ending
Notes/restrictions
Basic mode 0 Sys Ex. message Default range Input F7 1st byte fixed at F0
Advanced mode 1 1 Sys Ex. message Assignable Input F7 1st byte fixed at F0
Advanced mode 2 2 Single byte system message - -
[0-5, 7, 9, D, E] [DATA]
[CHECKSUM] buttons are invalid
Advanced mode 3 3 Any desired MIDI message Default range
Specified num-
ber of bytes
[CHECKSUM] button is invalid
Advanced mode 4 4 Any desired MIDI message Assignable
Specified num-
ber of bytes
[CHECKSUM] button is invalid
PCR-M30/50/80.book 72 ページ ２００５年１１月１０日 木曜日 午後２時４９分