20
4.2.3 Advanced
Miscellaneous Settings:
MAC Address Age-out Time
: Type the number of seconds that
an inactive MAC address remains in the switch's address table.
The valid range is 300~765 seconds. Default is 300 seconds.
Max bridge transit delay bound control:
Limit the packets
queuing time in switch. If enable, the packets queued exceed the
time will be droped. This valid value are 1sec, 2 sec, 4 sec and
off. Default is 1 second.
Broadcast Storm Filter Mode:
To configure broadcast storm
control, enable it and set the upper threshold for individual ports.
The threshold is the percentage of the port's total bandwidth
used by broadcast traffic. When broadcast traffic for a port rises
above the threshold you set, broadcast storm control becomes
active. The valid threshold value are 5%, 10%, 15%, 20%, 25%
and off.
Priority Queue Service settings:
First Come First Service:
The sequence of packets sent is
depend on arrive order.
All High before Low:
The high priority packets sent before low
priority packets.
WRR:
Weighted Round Robin. Select the preference given to
packets in the switch's high-priority queue. These options
represent the number of high priority packets sent before one
low priority packet is sent. For example, 2 High : 1 Low means
Summary of Contents for ES-3124REM
