63
2.4.3 Max bridge transmit delay bound
1.Max bridge transmit delay bound:
Limit the packets
queuing time in switch. If enable, the packets queued exceed
will be drop. Press
Space
key to set the time. This valid value
are 1sec, 2sec, 4sec and off. Default is off.
2.Low Queue Delay Bound:
Limit the low priority packets
queuing time in switch. If enable, the low priority packet stays
in switch exceed Low Queue Max Delay Time, it will be sent.
Press
Space
key to enable or disable this function.
3.Low Queue Max Delay Time:
To set the time that low
priority packets queuing in switch. Default Max Delay Time is
255ms. The valid range is 1~255 ms.
NOTE:
Make sure of “Max bridge transit delay bound control”
is enabled before enable Low Queue Delay Bound, because Low
Queue Delay Bound must be work under “Max bridge transit
delay bound control” is enabled situation.
Summary of Contents for ES-3124REM
