Edgewater Networks 318CC, Owner Assistance Manual

Page: 88 / 213

18 SEASTAR Hydraulics
FILLING AND PURGING
SEASTAR POWER ASSIST
Step 5
TURN CLOCKWISE
CLOSE LEFT SIDE
BLEEDER
TURN CLOCKWISE
• Holding the cylinder body (Front Mount cylinder) or rod (Side Mount
cylinder) to prevent the body/rod from moving, turn the steering
wheel clockwise until a steady stream of air free oil comes out of
the bleeder.
• While continuing to turn the wheel close the bleed fitting for your
application and let go of the cylinder body/rod.
CLOSE
RIGHT SIDE
BLEEDER
Outboard Front Mount & HC5332 Cylinder Side Mount / Splashwell Mount Cylinder All Balanced Cylinder. Inboard & Sterndrive Cylinders
TURN CLOCKWISE
CLOSE
RIGHT SIDE
BLEEDER
Step 6
• Complete electrical connections as outlined in your Installation
Owner’s Manual.
• Repeat Steps 2 – 5 of purging instructions with the P/A unit "ON"
Be sure to remove ALL air from the autopilot reser voir line.
If the system has an autopilot installed, ensure that the autopilot
pump is run for at least 10 seconds in both directions during Step 3
and Step 5.
NOTICE
CAUTION
Prior to operating system, perform Oil Level System Check, refer
to page 20.