Edgewater Networks 318CC, Owner Assistance Manual

Page: 58 / 213

19
Owner’s Manual
Lenco wire feeds
through existing oil
line hole in transom
Lenco upper mounting
bracket fits existing
Bennett mounting
holes
Existing Bennett
lower actuator
bracket
Existing Bennett trim tab
plane and hinge
recommend using 3M 5200 adhesive
caulking to bed the upper bracket
and screws.
DO NOT OVERTIGHTEN.
Attach the actuator to the upper
bracket using the 5/16-18 X 1-3/4"
(4.45 cm) large hex head bolt and
5/16-18 (.79 cm) hex nut provided.
6) You are now ready to attach the
Lenco Actuator to the blade.First
insert the pin part way through the
hole in the Bennett lower bracket
and insert through one of the four
black washers provided in the kit.
Place the actuator into the bracket
and tap the pin through. Continue
through the second washer and
other side of the bracket. Replace
the bracket screw removed in step
3. This will lock the pin in place and
prevent it from falling out.
7) Now you will need to hook up the
Lenco Actuator wires inside the
bilge/rigging area. First cut the wire
connector from the Bennett wire
harness where the pump used to
be. Strip the four harness wires and
connect to the four Lenco wires
using the heat shrink butt splices
provided in the kit. Make sure to
use the proper crimping tool and
then heat all connections for a tight
waterproof seal. Tie-wrap or secure
in some fashion to a dry location to
help prevent the connectors from
getting too wet. For further wiring
information, see wiring instructions
and diagram on next page.
Please follow the instructions and
drawings carefully. Call the Lenco
Service Department at 772-288-
2662 for technical assistance.
RetroFit Kit for Bennett Trim Tabs Installation Instructions