Edgewater Networks 268 Center Console, Owner'S Manual

Page: 29 / 196

28
Upholstery
Soap and water should be periodically used to clean the vinyl. Vinyl protector products can make
the seats slippery, which may not be desirable. When cleaning the vinyl, be gentle. Do not use
cleaners that contain ammonia, acetone, strong solvents, or powdered abrasive cleaners. They
can damage and shorten the vinyl’s life.
Sump Area
Your EdgeWater has a bilge area in the after part of the boat. This can be maintained well by
periodically using a boat bilge cleaner. Follow the directions carefully.
10.2 Engine
If you have a new engine with a built-in flushing device, the engine may be flushed without
cranking. If the engine does not have a built-in flush device, one may be purchased to fit.
To flush the engine, after connecting a water hose to the proper connection, turn on the water.
Put the engine control in the idle position and crank the engine. Only let it run a couple of
minutes. The gear case is water-cooled and is not designed to run out of the water for extended
periods.
Do not crank the engine without water running. Water acts as a coolant and also a
lubricant for the water pump.
Do not rev the engine when flushing; idle speed is sufficient!
The exterior of the engines will respond well to a good quality wax. This should be re-applied
every several months as the marine environment is a very harsh one and the constant sun
exposure will deteriorate your motor’s finish. Consult the engine manufacturer’s owner’s manual
for specific instructions. In areas where there is a conflict between this manual and the engine
manufacturer’s manual, the engine owner’s manual will take precedence.
11/ Exterior Equipment
11.1 Anchor Locker
The anchor locker on your new EdgeWater 268CC has been designed for a danforth style anchor.
On the 268CC the anchor locker is located forward on the centerline. Before using the anchor for
an extended period or overnight, make sure the free end of the anchor line is attached to the
boat’s anchor tie-down bracket, which is bolted underneath to the cleat forward of the locker.
Remember, your anchor line should be a minimum of 7 times the depth in which you
routinely operate.