Edgewater Networks 245CC, Owner Assistance Manual

Page: 53 / 234

SEASTAR and BAYSTAR Hydraulic Steering Systems 1-3
3) Is there enough room in the splashwell for full engine tilt?
Find the dimensions (A, B & C) of your splashwell. Check them
against the minimum splashwell dimensions for full engine tilt
for your engine and cylinder.
MOTOR WELL DIMENSIONS required for BayStar front mount outboard steering systems
A
C
B
i) Ensure there is no interference between the
BayStar cylinder rod and the splashwell
boot or engine controls & cables. ii) Dimensional restrictions also apply to
external motor mount brackets.
iii) Ensure dimension 'A' maintained through full
trim/tilt range.
iv) Maximum transom thickness 3" (76mm).
v) Engines less than 70HP may require up to
an additional 1" (25mm) of splashwell
clearance.
OUTBOARD–FRONT MOUNT
2) Check the BayStar cylinder dimensions through the full trim/tilt
range of the engine.
IS THE SPLASHWELL WIDE ENOUGH?
The HC4645H/47H/48H /58H require a 21" (534mm)
Splashwell width.
BAYSTAR CYLINDER PART# HC4645H/47H/48/H58H
2.625"
(67mm)
21" (534mm)
CYLINDER # OF A B C MIN. ENGINE
MODEL NO. ENGINES CENTER DISTANCE
HC4645H/47H/ 1 21" (534mm) 6" (153mm) 5" (127mm) N/A
48H/58H
2 Twin engine applications not available at this time
NOTES: