Edge-Core ECS4810-12M Layer 2, Management Manual

Page: 98 / 1236

C
HAPTER
3
| Using the Web Interface
Navigating the Web Browser Interface
– 98 –
Configure Domain 443
Add Creates an ERPS ring 443
Show Shows list of configured ERPS rings, status, and settings 443
Configure Details Configures ring parameters 443
CFM Connectivity Fault Management 449
Configure Global Configures global settings, including administrative status, cross-
check start delay, link trace, and SNMP traps
452
Configure Interface Configures administrative status on an interface 456
Configure MD Configure Maintenance Domains 456
Add Defines a portion of the network for which connectivity faults can
be managed, identified by an MD index, maintenance level, and the
MIP creation method
456
Configure Details Configures the archive hold time and fault notification settings 456
Show Shows list of configured maintenance domains 456
Configure MA Configure Maintenance Associations 461
Add Defines a unique CFM service instance, identified by its parent MD,
the MA index, the VLAN assigned to the MA, and the MIP creation
method
461
Configure Details Configures detailed settings, including continuity check status and
interval level, cross-check status, and alarm indication signal
parameters
461
Show Shows list of configured maintenance associations 461
Configure MEP Configures Maintenance End Points 466
Add Configures MEPs at the domain boundary to provide management
access for each maintenance association
466
Show Shows list of configured maintenance end points 466
Configure Remote MEP Configures Remote Maintenance End Points 467
Add Configures a static list of remote MEPs for comparison against
the MEPs learned through continuity check messages 467
Show Shows list of configured remote maintenance end points 467
Transmit Link Trace Sends link trace messages to isolate connectivity faults by
tracing the path through a network to the designated target node 469
Transmit Loopback Sends loopback messages to isolate connectivity faults by
requesting a target node to echo the message back to the source
471
Transmit Delay Measure Sends periodic delay-measure requests to a specified MEP within a
maintenance association
473
Show Information
Show Local MEP Shows the MEPs configured on this device 475
Show Local MEP Details Displays detailed CFM information about a specified local MEP in the
continuity check database
476
Show Local MIP Shows the MIPs on this device discovered by the CFM protocol 478
Show Remote MEP Shows MEPs located on other devices which have been discovered
through continuity check messages, or statically configured in the
MEP database
479
Table 6: Switch Main Menu (Continued)
Menu Description Page