ecoSMART Supervisor user, installer and technical service manual
25
EN
COOLING SETPOINT.
Shows the heat pumps connected to supervisor with cooling enabled, also displayed cooling setpoint of
each heat pump. The temperatures are the setpoint and the temperature gradient set point in case of installing exchangers in
each heat pump.
MENU 1.5. DHW
DHW STORAGE TANK.
Shows the heat pumps connected to supervisor with DHW enabled and the temperature set point of
DHW in each heat pump.
MENU 1.6. POOL
POOL.
Shows the heat pumps connected to supervisor with Pool enabled and the temperature set point of Pool in each heat
pump.
MENU 1.7. INFORMATION
All the information is displayed here concerning the operation of the supervisor and the heat pumps and the state of the
overall installation. It is possible to access this menu quickly by pressing the [←] key
from the main screen.
BRINE / PRODUCTION.
Shows the outlet and inlet temperatures of the brine and production circuits, the temperature jump in
each of them, the pressure in each of the circuits and the adjustment percentage of each of the circulator pumps.
SIMULTANEOUSLY PRODUCTION.
Shows the percentage of regulation in valves to make cogeneration mode. It only be shown
in HP1 with simultaneously heating and cooling production.
OUTSIDE TEMPERATURE.
Shows the current outdoor temperature, the heating and the cooling cut-off temperature, i.e. the
outside environment temperature above or below which the HEATING or COOLING mode are deactivated.
ON/OFF ECOGEO GROUP.
Shows heat pumps connected to supervisor, which are enabled, the current state of each one
(On/Off), and the heat pumps stopped or locked by alarm.
HP AVAILABILITY.
This screen shows the operating hours accumulated in each heat pump. Also, with an upward arrow shows
the next pump that turn on and with a downward arrow the next to turn off.
COMPRESSORS.
Shows the current rotational speed of each heat pump connected with the supervisor. Also shows if the
heating or cooling capacity is enough, excessive or insufficient.
ENERGY METER.
Shows the instantaneous heating and cooling capacity with this parameters calculate the Coefficient of.
Performance (COP), the Efficiency Energy Ratio (EER) and the Seasonal Performance Factor (SPF), considering in each time the
active energy.
Month energy METER.
Displays the energy values explained in the previous section accumulated over a month.
MONTH / ANNUAL ENERGY METER.
Displays the energy values explained in the previous section accumulated over a year.
VERSION.
Displays information related to the version of control program, bios and expansion valve driver installed in the heat
pump.
MENU 1.8. ALARMS
It is possible to access this menu quickly by pressing the [Alarm] key from the main screen.
ACTIVE ALARMS.
Displays the alarms that are currently active. All the alarms included in this menu will not allow the
compressor to start. If the cause of the alarm has been solved, it automatically disappears from the menu and once again the
compressor can start. There are some alarms which if repeated five consecutive times activate a permanent alarm. If this
occurs the heat pump cannot be started until the active permanent alarm has been manually reset.
RESET ALARMS.
Allows permanent alarms to be reset which were caused by a succession of five alarms resulting from the
same cause.
