Eco Heating Systems CB 105 HW, Installation, Service And User Manual

Page: 137 / 147

E93.1803.901 HW 138
Screens and settings
This screen is active during power up and will remain active until communication with the Main Control (the AL-
BUS) has been established.
After communication has been established the following
Status overview appears:
The Status overview has the three different sections that show specific information:
An example a Status overview and the different sections
Header
-
Left: For cascade systems the cascade icon is shown, with the cascade manager indication (M) or the
dependent number.
-
Center: Shows the CH and/or DHW disabled icons when CH and/or DHW is disabled
-
Right: Shows the time (only if the real-time clock is available).
Middle section
-
Left: Shows user-configured information (by default only the outside temperature):
Line Info
Top
Burner state (when enabled)
Middle Configured/selected temperature (one of the following):
▪
Outside temperature
▪
Demand based (Flow or DHW temperature based on active
demand)
▪
Flow temperature
▪
DHW temperature
▪
System temperature (module cascade flow/supply temperature)
▪
Cascade temperature (boiler cascade flow/supply temperature)
Bottom CH water pressure (when enabled)
-
Center: The house icon is always displayed.
-
Right side: Shows several status icons:
Icon Description
Cascade icon
CH Disabled
DHW Disabled
Header
Middle section
Footer
Icon Description
CH demand
DHW demand
Emergency mode is active (for cascade systems only)
Burner is on (and flame is detected)
Frost protection is active
Anti-legionella program is active.
Error is set in the Main Control (see footer for error description)