PLEASE NOTE: 6.5GB IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT
TO CHANGE WITHOUT NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.
EN
G
LI
SH
21
Support:
Support.Eccotemp.com
Shop Online:
www.Eccotemp.com
Close the manual gas shut off valve.
Turn off the power supply to the water heater. Close the manual water shut off valve.
Open all hot water taps in the house (Bathroom, kitchen, laundry, etc.). When the residual water
flow has ceased, close all hot water taps.
Have a bucket or container to catch the water from the unit’s drain plugs. Unscrew the drain plugs
to drain all the water out of the unit.
Wait a few minutes to ensure all water has completely drained from unit.
Clean the filter: Check the water filter located within the cold inlet. With a tiny brush, clean the
water filter of any debris which may have accumulated and reinsert the filter back into the cold
water inlet. Securely screw the drain plugs back into place. Hand- tighten only.
Remove by turning counter clockwise and then clean and
replace
1. Turn off the water inlet supply valve.
2. Open a hot water tap to release the line pressure
MAINTENANCE AND SERVICE
Clean the cold-water inlet filter.
(Refer to diagram below)
.
Be sure that all openings for combustion air are not blocked. If blocked, remove obstruction.
Check that the opening for exhaust is not blocked. If blocked, shutoff the water heater’s
combustion .And then after a while, remove obstruction.
DO NOT
touch while unit operating, otherwise you might get burnt due to high temperature.
Check the gas pressure.
Keep the area around the water heater clear. Remove any combustible materials, gasoline or any
flammable vapors and liquids.
The water heater should be checked at least once a year or as necessary
by a licensed technician.
If repairs are needed, any repairs should be done by a licensed technician.
The water heater’s lifetime may be extended by regular maintenance.
UNIT DRAINING AND FILTER CLEANING
