![background image](http://html2.mh-extra.com/html/eccotemp/6-5gb-builder-series/6-5gb-builder-series_installation-use-and-care-instructions_4858363013.webp)
PLEASE NOTE: 6.5GB IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT
TO CHANGE WITHOUT NOTICE. PLEASE VISIT WWW.ECCOTEMP.COM/SUPPORT FOR MORE INFORMATION.
EN
G
LI
SH
13
Support:
Support.Eccotemp.com
Shop Online:
www.Eccotemp.com
NOTICE:
The National Fuel Gas Code (NFGC) ma
ndates
a manual gas shut- off valve: See (NFGC) for complete
instructions. Local codes or plumbing authority requirements may vary from the instructions or diagrams provided
and take precedent over these instructions.
This product is a forced type gas water
heater. When powered on the waste gas
will be forced to exhaust outside under the
help of the draught fan.
Rain proof
INDOOR
gas water heater
Its rain proof design helps to stop the rain
from dropping into the water heater. The
water heater inhales air from outside to
burn and exhaust the gas waste to outside,
the user can operate the water heater
through a remote control.
Temperature control system controls and
coordinates the water, electricity, and gas
to make sure the outlet water temperature
is consistent.
Low start up water pressure
Flame-out protection, if the water heater
flames out suddenly, it will cut off the gas
automatically to make sure a gas leak does
not occur.
PERFORMANCE FEATURES
WARNING
The water heater has an automatic draining
function. When the water inlet pressure of
the water heater exceeds 145 psi - 174 psi,
the water heater will automatically drain.
Please do not place objects around the water
heater to avoid damage caused by water
immersion of the water heater. When the
water heater automatically drains the water,
it indicates that the water system pressure
is too high. After the pressure is reduced or
the water valve is closed, confirm that the
pressure meets the requirement for using
the water heater.
• The appliance will operate at reduced
performance below 49 psi water pressure
• For information relating to burner test
point pressures and injector sizes refer to
the name plate located on the right hand
side of the case for each model.
For information relating to overall
dimensions and connection point refer to
diagrams.
• Installing in areas over 1 mile above sea
level will reduce performance.
NOTES
PRODUCT DIMENSIONS