MAINTENANCE
Push the oil separator hose onto the valve cover.
STEP 10 – EXHAUST GAS COMPENSATOR & HOSE CLAMPS
Loosen the 2 hose clamps on the exhaust gas compensator by a hose clamp
pliers and put them aside.
Remove the exhaust gas compensator together with the 2 hose clamps from
both ends of the pipe.
Replace the exhaust gas compensator including the 2 hose clamps and fix
the exhaust gas compensator with the 2 hose clamps by a hose clamp pliers.
STEP 11 – OIL
Add oil to the engine. Fill a maximum of
40 litres
of oil through the filler neck.
Use a funnel to fill the engine.
Check the oil level on the dipstick to ensure that the engine is not overfilled.
To do this, briefly screw on the oil cover and then take it off again.
After checking the oil level, fasten the oil cap by a water pump pliers.
Fig. 5.37
Fig. 5.38
Fig. 5.39
Fig. 5.40
Fig. 5.41
Fig. 5.42
24
