EC POWER XRGI 6, Maintenance Instruction, Page: 19 / 50

MAINTENANCE
Only perform maintenance work on the XRGI ® system when it is not in
operation and is fully cooled down! Otherwise, there is a risk of burns from
hot components and/or scalding if substances should escape.
REQUIRED MATERIAL
EC POWER service kit for XRGI
® 9 ( Item No.: 01KIT2612 ) consisting of:

1 pc. exhaust gas compensator

1 pc. plug for measuring point

2 pcs. hose clamps

1 pc. vacuum sensor

1 pc. injector

1 pc. vacuum filter

1 pc. lambda sensor

1 pc. gasket valve cover

1 pc. air filter

3 pcs. spark plugs

4 pcs. engine oil

1 pc. oil filter

2 pcs. zero pressure hose Ø2,0x1,5
REQUIRED TOOLS

Oil suction pump

16 mm spark plug wrench

Oil filter spanner

17 mm socket insert

Torque wrench

10 mm socket insert

Water pump pliers

3 mm Allen screwdriver

Hose clamp pliers

5 mm Allen screwdriver

Funnel

10 mm ring spanner

Feeler gauge

24 mm ring spanner

FS2009USB programming device.

10 mm open-ended spanner

Flue gas analyser

17 mm open-ended spanner

Lambda sensor top long ½

19 mm open-ended spanner

10 mm socket spanner
Before commencing maintenance work, shut down the XRGI
®
system at
the user level on the iQ-Control Panel and at the main switch. Close the
gas valve and unplug the Q-Heat Distributor.
5. MAINTENANCE XRGI
®
9
Fig. 5.01
18