LX20G_Manual_en_v2.1
Page 50 /
69
situation. Choice of this option result in sending a report to monitoring station if
time of picking up the phone exceeds determined time limit.
Note
: This operation of this device follows if it works with new protocol. If
transmitter is to work in emulation PX mode (See chapter 7.2) the above mentioned
situation will result in sending “No telephone line” message.
7.9.1.7.
Report “intervals too long”
This option is being used if in configuration PSTN line- LX- Alarm Control Panel
there are not other telecommunication devices. If such device will be connected and
telephone number will be dialled (and a call will follow) after expiry defined time
limit (counted since conclusion of last digit dialling) the transmitter sends a
message. This operation prevents unauthorised installation of additional devices.
Note
: This operation of this device follows if it works with new protocol. If
transmitter is to work in emulation PX mode (See chapter 7.2) the above mentioned
situation will result in sending “No telephone line” message.
7.9.1.8.
Generate dial tone
Some alarm control panels require that during a receiver picking up a tone of
dialling was actuated. To enable cooperation with a transmitter it is possible to
make a transmitter to generate such tone.
7.9.1.9.
Generate Call-ID for incoming GSM voice calls
Check this option to turn on generation of Call-ID signal for incoming GSM voice
calls.
Note:
To connect Jablotron's SP-02 speaker phone, please use following diagram
(in parallel with SP-02 device and T1/R1 terminal connect 330kΩ/0,6W resistor).
