LX20G_Manual_en_v2.1
Page 30 /
69
7.3.3.
Outputs configuration
Tab „Output 1 (OUT1)” , „ Output 2 (OUT2)” and „ Output 3 (OUT3)” specify
conditions of switch outputs. Settings for all outputs are identical so they will be
described in one chapter.
7.3.3.1.
Activation mode and timing
Thanks to this option you may choose output operation mode. There are two
operation modes available:
o
Bistable - connection follows for indefinite time- up to the moment of
disconnection of power for module or remote command which switches
output off,
o
Monostable - connection follows for time defined by user - every 100ms.
7.3.3.2.
Conditions
Defines conditions for activating both of outputs. User can set following conditions:
o
No connection to server (immediately after detection);
o
No GSM signal (immediately after detection);
o
Detection of incoming call from defined telephone number;
o
Dependent on state transitions from non-active to active of one of the inputs.
Outputs can be also activated by internal watchdog, which can be configured
in “Link control” group.
7.3.4.
Advanced outputs control
The user is able to determine an alternative course of action to go over basic
outputs configuration function described in
0 .
In the “Advanced outputs control”
