Communications
Copyright © 2007-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-50H November 2011
87
Communication via Email
The SC200 system controller can be configured to send Email alarm messages when an alarm
occurs.
► To set up Email communications:
1
Set up Ethernet communications and connect the SC200 to the IP network. See Ethernet
Communications on page
2
In DCTools/Web go to
Configuration
>
Communications
>
Email Notifications
.
3
Enable
Email Notifications
.
4
Set the following parameters:
SMTP Server IP Address
and Port:
The details of the mail server that will be used to send
the Emails.
Return Address:
If not blank, any delivery failure notifications will be
sent to this address.
Subject Prefix:
An Email subject prefix that will be added to each
Email's subject to allow automatic processing of the
Email.
5
For each Email recipient (up to 6), set the following parameters:
Address:
The recipient's Email address.
Level:
The severity of alarms that are to be reported to this
recipient.
Select
Warnings And Above
to send an Email when
an alarm with a severity of
Warning
or above
changes state.
Select
Minor And Above
to send an Email when an
alarm with a severity of
Minor
or above changes
state.
Select
Major And Above
to send an Email when an
alarm with a severity of
Major
or above changes
state.
Select
None
to send no Emails.
Select
Critical Only
to send an Email when an
alarm with a severity of
Critical
changes state.
Delay:
The alarm Email will be delayed by this length of
time. During this delay, the SC200 will collate all the
events that occur into a single Email.
Test Emails can be sent to test the Email Communication setup.
► To send a test Email:
1
In DCTools/Web go to
Configuration
>
Communications
>
Email Notifications
.
2
Click the
Send Test Email
button on the row of the Email address to be tested.
