Eaton Powerware 225 kVA Three-Phase Power Distribution Unit, Installation And Operation Manual

Page: 72 / 142

COMMUNICATION
EATON Powerware
®
225 kVA PDU Installation and Operation Manual
S
164201629 Rev D www.powerware.com
7−8
7.4.4 Configure the Card
To configure the card:
1. Type 1 on the Main Menu to display the Web/SNMP Card Settings screen [see
Figure 7-5(a)].
(a)
(b) (c)
Figure 7-5. (a) Configure Card Setting, (b) Set Powerware ConnectPDU Web/SNMP Card IP Address, and (c) Save and Exit
2. Type 1 to display the Set the IP Address, Gateway Address, and MIB System
Group screen [see Figure 7-5(b)].
3. To set the IP Address, type 1 and press Enter . Type the IP Address (see the
Checklist on page 7−5) and press Enter .
4. Type 0 to return to the previous menu.
5. Repeat Steps 3 and 4 to set the Gateway Address and Network Mask.
6. Change any other options as needed for this particular configuration by typing the
corresponding number shown in the menu.
Each Configuration Menu setting is described in detail in the Appendix of the
Powerware ConnectPDU Web/SNMP Card User’s Guide . The other options can
be changed later if you prefer.
7. Type 0 until returned to the Main Menu [see Figure 7-5(c)].
8. Type 0 to save all settings and exit the card configuration.
9. Verify network communication by using a Web browser. Type the IP Address of
your card and select
Go . The Powerware ConnectPDU Web/SNMP Card
Summary page opens (see Figure 7-6).
Figure 7-6. Powerware ConnectPDU Web/SNMP Card Summary Page
NOTE
Once the card is reachable on the network, you can use a Web browser, Telnet, or similar utility to
adjust any of the configuration settings. The menus are identical to those seen during serial configuration and
are password−protected for Superuser access only.