2. Important Safety Information
WARNING SYMBOLS
This
WARNING!
Symbol calls attention to a procedure or practice which, if not adhered to, could result in
personal injury. Do not proceed beyond a
WARNING
sign until the indicated requirements are fully under-
stood and met.
This symbol calls attention to important clarifying point of information which will help insure a successful
installation.
Failure to adhere to the following warnings may cause personal injury or damage to your
enclosure rack.
1. WARNING! Paramount Enclosure components can be very heavy. It is recommended that several
people take part in the unpacking process. When lifting Paramount components or electronic equip-
ment, there should be at least one person for every 40 lbs. of weight to be lifted.
2. WARNING! The enclosure rack must be stabilized before installing any roll-out type accessory com-
ponent or electronic device into the rack. Failure to stabilize the rack before installing equipment may
cause the enclosure to tip over.
3. WARNING! Load the heaviest electronic devices and accessory components into the enclosure rack
first, and place them near the bottom of the enclosure to prevent the enclosure from becoming top-heavy.
4. WARNING! Never extend a roll-out type electronic device or accessory component from an enclosure
rack that is supported by casters. Doing so may cause the enclosure to tip over. If your cabinet is sup-
ported by casters, refer to the instructions on stabilization methods.
5. WARNING! Never extend more than one roll-out type electronic device or accessory from a stabilized
enclosure rack at a time. Doing so may cause a stabilized enclosure rack to tip over.
6. WARNING! Do not sit, stand, or climb on any extended roll-out type electronic device or accessory.
7
. WARNING! To reduce the risk of overload, do not load any Power Distribution Unit (PDU) with more
than 80 percent of its rated amperage capacity.
8. WARNING! There must be an uninteruptable safety earth ground from the main power source to the
Power Distribution Unit’s (PDU) power cord set. Whenever it is likely that ground has been impaired,
disconnect the PDU’s power cord until the ground has been restored.
WARNINGS!
2
Pub Num: MN159002EN rev1.0
Paramount Enclosure
Installation Guide
Summary of Contents for Paramount Enclosure
Page 1: ...Eaton Data Center Racks...
Page 2: ...U...
