29
ANTI-TIP STABILIZER FOOT
1. Fasten the Stabilizer Foot guide channel to the base frame with four ¼-20 x ½” hex head self tapping screws.
See figure
9-17
.
2. Install an edge liner to the bottom edge of each guide slot. See enlarged detail.
3. Fasten the left and right kick plates to the base frame with #10 x 3/8” phillips pan head self tapping screws.
See figure
9-17
.
4. Slide the Stabilizer Foot through both guide holes. Install one #10 x 3/8” phillips pan head self tapping screw
into the end of the tube. See figure
9-18
.
5. Slide the Stabilizer Foot all the way out. Adjust the contact screw so that it contacts the floor. See figure
9-18
.
Extension foot
guide channel
Base frame
1/4”-20 x 1/2” hex head
self-tapping screws
L.H. Partial
kick plate
R.H. Partial
kick plate
#10-24 x 3/8” phillips pan
head self-tapping screws
Figure
9-17
Edge liner
Figure
9-18
Guide plate
#10-24 x 3/8” phillips pan
head self-tapping screw
Contact screw
Extension foot tube
Pub Num: MN159002EN rev1.0
Paramount Enclosure
Installation Guide
Summary of Contents for Paramount Enclosure
Page 1: ...Eaton Data Center Racks...
Page 2: ...U...
