EC500 Controller Handbook
Copyright © 2019 Eaton Corporation. All Rights Reserved.
Issue A March 2019
Page 35 of 107
Parameter
Description
Where to find:
Output Voltage
DC output voltage as measured by rectifier
Display: NA
Web:
Home>System
Status>Rectifier>Individual
Rectifier Status
Output Current
DC output current as measured by rectifier
Status
Communication Status
DC State
Internal DC / DC stage status
Share Factor
Current percentage deviation
Input Voltage
Input AC voltage as measured by rectifier
Input Current
Input AC current as measured by rectifier
Temperature Rise
Heat Sink temperature rise (
C)
All parameters may not be available for every type of rectifier
Configuration
Parameter
Description
Where to find:
Installed SMR
Defines maximum number of Rectifier installed in
system. Controller will register only these many
rectifiers.
Display:
Menu>Settings>Rectifier
Settings
Web:
Home>Settings>Rectifier
Settings
Installed SMR on
CAN1 Bus
In case Controller is configured for two CAN buses,
specify number of rectifiers on CAN Bus number 1,
else this setting is not available.
Installed SMR on
CAN2 Bus
In case Controller is configured for two CAN buses,
specify number of rectifiers on CAN Bus number 2,
else this setting is not available.
Current Limit
Defines maximum current limit of individual
rectifier.
Over Voltage
Indicates set value for DC High Voltage alarm
threshold of rectifier.
Ext Over Voltage
Extended over voltage to extend the Over Voltage to
the Maximum of 67V.
Under Voltage
Indicates set value for DC Low Voltage alarm
threshold of rectifier.
ID De-Register
To De-register the rectifier Individually or All.
ECO Mode
Refer to Section Economy Mode on Page 38.
Start Voltage
Minimum Voltage to start the rectifier.
Rectifier Default
Voltage
In case controller communication is lost, rectifiers
will target this voltage. For this setting to be present,
the rectifier should communicate at least once with
the controller. This happens at factory level.
Rectifier Default
Current Limit
In case controller communication is lost, rectifier
current limit will fall back to this limit. For this
setting to be present, the rectifier should