background image

Danfoss does not take responsibility for incorrect installation or

any frequency interference.

Chance of unintended machine movement on start up.

Ensure the machine is stopped for the entire duration of the

assembly process.

Keep the work area free and wear protective clothing.

Connect the power supply and the output connections using
the connection block diagram provided with the system. The
receiver will enter into scanning mode and show the following:

ORDER

RELAY
ID
DATA
SIGNAL
HARDOK
POWER
CANRUN
CANERR

OFF
ON
BLINKING

LED scanning mode (receiver)

LED

Description

DATA

There is not another system active
in the area

SIGNAL

OFF; channels are signal free

BLINKING; RF signal detected on

the channels

HARDOK

GREEN; Absence of faults on the
boards

POWER

Power supply OK

CANRUN

Communications with expansion
boards are OK

*

*

 Only in receivers with CAN connection (except RCAN)

OUT

IN

RF signal detected

Incorrect ID signal from Ikusi system

CORRECT ELEMENTS

Abc

Abc

INCORRECT ELEMENTS -Check 

troubleshooting guide

Display scanning mode (receiver)

1. Place a charged battery in the transmitter
2. Turn the contact key
3. Push and pull out the STOP button

The LED of the transmitter will flash orange-green. If the
transmitter has a display, it displays the identification of the
machine, as well as the battery level

4. Press the start button

The green LED should now light indicating the transmitter
is transmitting

5. Turn off the transmitter using the STOP button

ORDER

RELAY
ID
DATA
SIGNAL
HARDOK
POWER
CANRUN
CANERR

OFF
ON
BLINKING

LEDs operational mode (receiver)

OUT

IN

Correct ID (the icon shows the quiality of the link)

Linked state

No Ikusi RF signal detected(the icon shows the 

quality)

Incorrect ID ( the icon shows the quality)

Display operational mode (receiver)

Installation Guide

Remote Control

TM70 and Ikontrol

©

 Danfoss | January 2019

AI293579926818en-000101 | 1

Reviews: