16
Compass sit-to-stand
Installation Manual
COMPASS SIT-TO-STAND INSTALLATION MANUAL
Eaton.com/compass
SECTION III – Assembling the desk
cont’d.
WARNING
During the assembly process, components may become
unstable� Some components will be heavy� To reduce the
risk of personal injury and product damage, always ensure
a sufficient amount of personnel are present during the
assembly process and final installation�
•
Place worksurface assembly onto lift columns� Carefully
guide the lift motor housings into their respective locations�
CAUTION
Pinched electrical cables may cause risk of electrical
shock or equipment damage� Use care and visually verify
to avoid pinching any previously installed cables�
•
Secure with (4) M6 x 10 Phillips head screws (D) into each
lift motor housing. No lock washers are used. Use a #3
Phillips bit� DO NOT TIGHTEN SCREWS�
NOTICE
Start all screws in their holes before tightening�
NOTE:
In certain cases, some bolts may be difficult to access�
They can be installed after power is connected and the
work surface raised from its base position�
•
After all lift motors are assembled, place desk assembly in
final location and level�
•
Connect AC cord to AC outlet�
•
Initialize lift system - per page 18�
•
Cycle lift system to 18" twice�
•
Tighten all lift motor screws�
Install Cable Chain Kit
•
The kit parts are designed to allow attachment to either
the left or right stretcher of the assembled desk�
•
Mount cable chain directly to worksurface using
(2) #10 x 1" Phillips head screws (A).
•
Mount to stretcher using (2) #8-32 X
1
⁄
4
" thread forming
screws (H) and (2) #8 flat washers (L).
Cable chain
#8-32 X
1
⁄
4
" screws
and # 8 flat
washers
#10 x 1"
wood
screws
Pre-assembled
worksurface
with cabling
M6 x 10 screws
(4) Per lift column
Lift
Column
