Eaton APS6-400 Series, Installation And Operation Manual

Page: 94 / 114

Access Power Solutions Installation Guide (APS6-400 Series)
86
Copyright © 2009-2010 Eaton Corporation. All Rights Reserved.
IPN 997-00012-53B December 2010
System Controls
Equipment Required:

DC Load bank
Test Test procedure Adjustment
Voltage Control
Note 1

Apply a load to the power system.

With DCTools , ensure the bus voltage matches the Target
Voltage as shown on the Voltage Control Summary of
DCTools .
None
Temperature
Compensation
Note 2

Heat the battery temperature sensor.

Ensure the system voltage changes in accordance with the
configured slope.
None
Equalize

Set the Equalize Duration to 1 minute.

Start an Equalize .

Ensure the system voltage increases to the Equalize Voltage .

Ensure the SC200 or SC100 indicates an Equalize has
started.

Ensure the Equalize stops after the 1 minute duration.

Return the Equalize duration to the original setting.
None
Fast Charge
Note 3

Set the Fast Charge Max Duration to 1 minute.

Set the Fast Charge Voltage Threshold to a value
approximately 1V below the system float voltage.

Connect load to the system.

Turn off the ac to the system.

Allow the system voltage to fall below the Fast Charge
Voltage Threshold.

Turn on the ac.

Ensure the system performs a Fast Charge.

Ensure the SC200 or SC100 indicates a Fast Charge has
started.

Ensure the Fast Charge Voltage is correct.

Ensure the Fast Charge stops after 1 minute.

Return the Fast Charge settings to the original values.
None
Generator Control
Option
(SC200 only)
Note 4

Set the Voltage Threshold to a value approximately 1V below
the system float voltage.

Connect load to the system.

Turn off the ac to the system.

Allow the system voltage to fall below the Voltage
Threshold.

Ensure the system performs a Fast Charge.

Ensure the SC200 indicates a Generator Enable .

Ensure the Generator Enable digital output activates.

Turn on the ac.

Ensure the Generator Enable stops after 1 minute.

Return the settings to the original values.
None
Battery Current
Limit
Note 5

Reduce the Battery Current Limit setting to 5%.

Connect load to the system.

Turn off the ac to the system.

Allow the battery to discharge for a period.

Turn on the ac.
None