8
ENGLISH
NOTE: For easier and faster cleaning, consider purchasing the Rapid Clean Kit
(C900042.M)
STEP ONE: CLEAN UP INSTRUCTIONS
NOTE: Proper clean up is essential to keep your sprayer in optimum working
condition. Dried by-products act like glue and will cause moving parts to stick. Failure
to properly clean your paint sprayer will damage the unit. Taking the time to clean
your sprayer immediately after use will help your sprayer last longer and work
correctly. If you are finished with the project or are not going to use the sprayer
within the day, you must follow these instructions for proper clean up. Never store
the sprayer longer than 30 minutes without cleaning.
1. Unplug sprayer from electrical outlet and pull trigger on spray gun so material
inside unit flows back into the container.
2. Empty any remaining (stain or paint) material from the container.
3. Fill container approximately 1/2 full with appropriate cleaning solution. For latex,
use warm soapy water; for oil-based, use a cleaning solution recommended by the
material manufacturer.
4. Plug sprayer into an electrical outlet.
5. Press the switch of the sprayer until the cleaning solution passes through the spray
nozzle for several seconds. (See Figure A.)
6. Remove container and properly discard the cleaning solution.
7. Unplug the sprayer from the electrical outlet.
STEP TWO: CLEAN UP INSTRUCTIONS FOR THE SPRAY TIP
Use the brush (included) to complete the following steps.
1. Unplug sprayer from electrical outlet and pull trigger on spray gun so material
inside unit flows back into the container.
2. Unscrew the container and discard any remaining cleaning solution.
3. Remove the pick-up tube from the sprayer and clean it with warm, soapy water.*
(See Figure B.)
4. Unscrew the air cap ring, remove the winged spray cap and the inner spacer.
Clean all three with warm, soapy water.* (See Figure C.)
5. Clean the sealing ring found between the container and the housing with warm,
soapy water*.
6. Clean the Brass Fluid Nozzle housing and the unit with warm, soapy water.*
Remove
the Brass Fluid Nozzle by unscrewing and clean around the brass needle with the
brush provided. (See Figure D.)
7 . Let the components dry thoroughly and reassemble the unit.
8. Store the unit.
* If you’ve been using oil-based liquids, clean these parts with the liquid that the
manufacturer recommends (Example: mineral spirits).
MAINTENANCE
Air filters should be inspected periodically. If it is excessively dirty, follow these steps
to remove and replace: (Figure F.)
1. Keeping the sprayer upright at all times.
2. Replace filters (P/N C900088.M) and reinstall lid.
SERVICING A DOUBLE-INSULATED PRODUCT
In a double-insulated product, two systems of insulation are provided instead of
grounding. No grounding means is provided on a double insulated product, nor should
a means of grounding be added to the product. Servicing of a double-insulated product
requires extreme care and knowledge of the system and should only be done by
qualified service personnel. Replacement parts for a double-insulated product must be
identical to those parts in the product.
CLEAN UP & MAINTENANCE
A
B
F
C
Brass
Fluid
Nozzle
Brass
Fluid
Needle
D
