30
E-flite LR-1A Pogo 15e ARF Assembly Manual
Battery and Wing Installation
Required Parts
Wing assembly
Fuselage assembly
Motor battery
Servo extension: 3-inch (76mm)
4mm washer (2)
Wing bolt plate
4mm x 30mm machine screw (2)
Required Tools and Adhesives
Phillips screwdriver: #2
Hook and loop strap
Hook and loop tape
1. Secure the battery in the fuselage using a hook
and loop strap. Also, place hook and loop tape on
the battery and fuselage where they contact each
other to prevent the battery from moving.
2. Plug the aileron servo extension into the receiver.
Route the extension through the servo tray so it can
be accessed from the bottom of the fuselage.
3. Plug the aileron servo lead into the servo
extension. Mount the wing following the procedure
described earlier in this manual.
Landing gear Installation
Required Parts
Main wheel (2)
Axle with hardware (2)
Assembled airframe
Aluminum landing gear
1/4-20 x 2-inch nylon bolt (2)
Required Tools and Adhesives
Felt-tipped pen
Drill
Light machine oil
Drill bit: 5/32-inch (4mm)
Threadlock
Flat blade screwdriver
Hex wrench or ball driver: 3mm
1. Locate the aluminum landing gear. The straight
side of the gear faces to the front of the aircraft.
