E-FLITE LR-1A Pogo 15e, Assembly Manual

Page: 4 / 40

4 E-flite LR-1A Pogo 15e ARF Assembly Manual
Important Information
Regarding Warranty Information
Please read our Warranty and Repair Policy section
on Page 36 before building this product. If you as
the Purchaser or user are not prepared to accept the
liability associated with the use of this Product, you are
advised to return this Product immediately in new and
unused condition to the place of purchase.
Using the Manual
This manual is divided into sections to help make
assembly easier to understand, and to provide breaks
between each major section. In addition, check boxes
have been placed next to each step to keep track
of its completion. Steps with a single circle (

) are
performed once, while steps with two circles (
 
)
indicate the step will require repeating, such as for a
right or left wing panel, two servos, etc.
Remember to take your time and follow the directions.
Covering Colors
HANU870 White
HANU884 Cub Yellow
HANU885 Midnight Blue
Recommended Radio Equipment
You will need a minimum 4-channel transmitter,
receiver and four servos. You can choose to purchase
a complete radio system. If you are using an
existing transmitter, just purchase the other required
equipment separately. We recommend the crystal-
free, interference-free Spektrum ™ DX6i 2.4GHz DSM ®
6-channel system. If using your own transmitter, we
recommend the JR SPORT
™
MN48 Mini servos.
If you own a Spektrum radio, just add a DSM2 ™ receiver
and three JR SPORT MN48 mini servos. We show the
installation of the AR6200 receiver in the manual.
Transmitter
SPM6600 DX6i 6-Channel Full Range w/o
Servos MD2
or Purchase Separately
SPMAR6200 DSM2 AR6200 6-Channel
Receiver Ultralite
Servos
JSP20040 MN48 Mini Servo (3)
or
SPMSH5000 SH5000 High-Speed
Mini Servo (3)
Additional Items
JSP98100 3-inch (76mm) Servo
Extension (2)
Required Tools and Adhesives
Tools & Equipment
Drill Epoxy brush
Felt-tipped pen Flat blade screwdriver
Low-tack tape Hook and loop strap
Light machine oil Hook and loop tape
Long nose pliers Mixing cup
Mixing sticks Needle nose pliers
Paper towels Pencil
Pin vise Phillips screwdriver: #1, #2
Rubbing alcohol Ruler
Sandpaper T-pins
Side cutter Square
Straight edge Toothpicks
Open end or box wrench: 10mm
Hobby knife with #11 blade
Hex wrench or ball driver: 2.5mm, 3/32-inch, 3mm
Drill bit: 1/16-inch (1.5mm), 5/64-inch (2mm),
1/8-inch (3mm), 5/32-inch (4mm)
Adhesives
30-minute epoxy Thin CA
Medium CA Threadlock
Recommended Sport Setup
Motor: Power 15 Brushless 975Kv
Outrunner (EFLM4015A)
Speed Control: 40A Pro Switch-Mode BEC BL
ESC (EFLA1040)
Battery: 3200mAh 3S 11.1V 30C Li-Po
Battery (EFLB32003S30)
Spinner: 2-inch Aluminum Spinner
(EFLSP200)
Propeller: 10 x 10E (APC10010E)
The Spektrum trademark is used with permission
of Bachmann Industries, Inc.