28
E-flite LR-1A Pogo 15e ARF Assembly Manual
8. Use a pin vise and 5/64-inch (2mm) drill bit to
enlarge the hole in the servo arm that is 3/8-inch
(10mm) from the center of the servo horn.
9. Use a square of straight edge to make sure the
rudder is in alignment with the fin.
10. With the rudder and rudder servo centered,
place the servo horn on the servo. Use a felt-tipped
pen to mark the rudder pushrod where it crosses
the hole in the arm that was previously enlarged.
11. Remove the rudder pushrod from the fuselage.
Remove the nut and clevis from the pushrod wire.
Set the nut and clevis aside for now.
12. Use long nose pliers to bend the pushrod wire
90 degrees at the mark made in Step 10.
13. Slide the wire through the hole in the servo
horn. Use a nylon pushrod keeper to secure the
wire to the servo horn.