Dynapac CA270, Instruction Manual

Page: 93 / 99

Maintenance - 1000h
ICA270-IN2EN1.pdf 2012-11-05
Rear axle transmission - Oil change
Fig. Rear axle - draining
5. Level/Filler plug
6. Drain plug
7. Breather
Before draining the oil, use the breather (7) to release
possible internal pressure.
Wipe clean and remove one of the two level/filler plugs
(5) and the drain plug (6) and drain the oil into a
suitable receptacle. The volume is approximately 1
liter (1.1 qts).
Save the oil and hand in to an
environment-friendly waste disposal station. Save the oil and hand in to an
environment-friendly waste disposal station.
Clean and refit the drainage plug (6) and tighten with
torque (60Nm).
Fill with fresh oil in the level/filler hole until the oil level
reaches the lower edge of the plug hole. Use
transmission oil, see lubricant specification.
Use transmission oil, see lubricant specification.
Refit the level/filler plug (5) and tighten with torque
(60Nm).
Rear axle's planetary gears - Draining the oil
Fig. Oil drain - planet gear
4. Level/Filler plug
Before draining the oil rotate the wheel so that the plug
(4) is at the highest positions (pos.A) and partially
unscrew the plug to release possible pressure.
Then rotate the wheel so that the plug (4) is at its
lowest position (pos.B).
Wipe clean and remove the plug (4) and drain the oil
into a receptacle. The volume is approx. 2 liters (2.1
qts).
Save the oil and hand in to an
environment-friendly waste disposal station. Save the oil and hand in to an
environment-friendly waste disposal station.
85