DynaGen Tough TG350AMF, User Manual

Page: 22 / 49

Configuration 21
© 2012 DynaGen Technologies Inc. TOUGH Series User Manual
4 Configuration
Changing the following settings can alter the way the engine is started and stopped and how the
controller reads inputs, control outputs, and interprets and act on sensor data. When configuring
settings be sure to thoroughly read their descriptions to understand how they will affect the controller.
The following list is a breakdown of the settings menu structure inside the controller.
· Operator Setup
a. Lamp Test
b. Display
i. LCD Reverse
ii. LCD Contrast
iii. Page Scroll
iv.Message Pop-Up
v. LCD Backlight
c. Date/Time
i. Date Change
ii. Time Change
iii. Daylight Saving
d. Units
i. Temp. Unit
ii. Pressure Unit
e. Run from OFF
i. Run from OFF
· Device Info.
a. About Controller
b. Maintenance
· Events History
· Sw itched I/O
a. Sw itched IN
i. X Function
ii. X Active Modes
iii. X Trigger
b. Sw itched OUT
i. X Function
· Sensors
a. Battery
i. Batt Recharge
ii. Recharge Setup
iii. Setpoints
iv.Crank Low Batt
b. Engine Speed
i. Signal Source
ii. Speed Settings
iii. Setpoints
c. Engine Temp.
i. Signal Source
ii. Sensor Type
iii. Trim Offset
iv.Setpoints
a. Oil Pressure
i. Signal Source
ii. Sensor Type
iii. Trim Offset
iv.Setpoints
b. Fuel Level
i. Signal Source
ii. Sensor Type
iii. Trim Offset
iv.Setpoints
c. Aux Sensor 1
i. Signal Source
ii. Mode Select
iii. Trim Offset
iv.Mode Settings
v. Setpoints
d. Aux Sensor 2
i. Signal Source
ii. Mode Select
iii. Trim Offset
iv.Mode Settings
v. Setpoints
· Timers
a. Engine Logic
i. Delay To Start
ii. Preheat Time
iii. Crank Time
iv.Midheat Time
v. Crank Rest Time
vi.Crank Attempts
vii.Fuel Crank Rest
viii.RPM Disconnect
ix.Postheat Time
x. Warm-up Time
xi.Cooldow n Delay
xii.ETS On Duration
b. Exerciser
i. Enable
ii. Delays
iii. Schedule
c. Maintenance
i. Reset Counter
ii. Enable Counter
iii. Count Interval
d. Trigger Delays
i. Config Inputs
· AC Monitor
a. Genset Voltage
i. Voltage Source
ii. Scaling Factor
iii. Nominal Volts
iv.Volt Sel Inputs
v. V Setpoints
vi.H Setpoints
b. Mains Voltage
i. Mains Source
ii. Scaling Factor
iii. Nominal Volts
iv.AMF/ATS Mode
v. AC Stable Time
vi.V Setpoints
c. ATS Outputs
i. Genset Drive
ii. Genset Trigger
iii. Genset ATS Dly
iv.Mains Drive
v. Mains Trigger
vi.Mains ATS Dly
vii.Mains Open
· Communications
a. J1939 Bus
i. ECM Model
ii. Loss of ECM
iii. DTC Display
iv.Active DTC Log
v. Read Stored DTC
vi.Auto Pow er ECM
vii.ECM Pow er Delay
viii.Cummins Idle
ix.SPN Conversion
x. EMS2B Freq Sel
xi.EMS2B Acc Pedal
2. Other Config
a. Passcode
i. Bypass
ii. Timeout
iii. Number