DURKOPP ADLER DAC eco M-Type, Instructions For Use Manual

Page: 32 / 40

Troubleshooting
Instructions for use DAC eco M-Type - 01.0 - 10/2015 30
Types of error messages
Listing of codes
Type Description Remedial action
Error Serious error:
Work cannot be con-
tinued
• Switch off the controller
• Correct the state that resulted in
the error
• If nec., contact customer service
Warning Error
Work cannot be con-
tinued
• Correct the state that resulted in
the error
Information Information:
Work can be contin-
ued • Switch the controller off and on
again
• If nec., correct the state that
resulted in the message
Code Type Description Remedial action
1 Warning Operation lock • Check tilt sensor on
machine
2 Information Low voltage warning
(1st threshold):
Live voltage < 180 V
AC • Check the line volt-
age
• Stabilize the line
voltage
• Use generator
3 Warning Foot pedal not in 0
position • Remove foot from
foot pedal
4 Error Foot pedal not con-
nected • Connect foot pedal
5 Error Sewing motor
encoder plug (sub D,
9 pin) is not con-
nected • Connect encoder
cable to the control
system, use the cor-
rect connector
6 Error Sewing motor
blocked • Eliminate stiff move-
ment in the machine
7 Error Sewing motor over-
load • Eliminate stiff move-
ment in the machine