DURKOPP ADLER DAC eco M-Type, Instructions For Use Manual

Page: 26 / 40

Operation
Instructions for use DAC eco M-Type - 01.0 - 10/2015 24
You can reduce the holding force by briefly pressing
button
S2 .

The holding force increases or decreases in increments of
0.5 A.
LED S1 flashes for the digit before the decimal point, and
LED S2 for the decimal digit.
The higher the set value, the stronger the holding force.
4. Press and hold button S1 to confirm input.
5.3.5 Setting positions
The following positions can be set:
• Reference position
• Position 1
• Position 2
The positions have to be set once:
• during initial start-up (

S. 17 )
• after replacing the controller
• after replacing the motor or setpoint device
Setting the reference position
The reference position establishes a reference between the syn-
chronizer and the actual mechanical position.
To set the reference position:
1. Briefly press button S1 five times.

LED S1 flashes briefly five times.
2. Press and hold button S1 .

The MESSAGE LED, LED S1 , and LED S2 illuminate.
Hardware damage due to incorrect setting.
An incorrect setting can cause problems in the
sewing process.
Only qualified technicians may make this setting.
CAUTION