DURKOPP ADLER 969 Classic, Service Instructions Manual

Page: 81 / 122

Setting the thread cutter
Service Instructions 969 - 06.0 - 03/2019 79
Fig. 61: Setting the initial position of the thread cutter and the position of the thread-pulling
knife (3)
6. Insert a feeler gage (0.9 mm) into the gap (8).
7. Push the knife carrier (9) to the right against feeler gage and feed dog
mounting plate (10).
8. Push the lever (2) to the left.
9. Place a feeler gage (0.1 mm) between roll (12) and cutoff curve (11)
at handwheel position 80°.
10. Push the roll (12) down.
11. Tighten the screw on the lever (2) through the assembly opening (1).
12. Push the lever (4) to the right.
13. Tighten the screw (3).
(8) - Gap
(9) - Knife carrier
(10) - Feed dog mounting plate
(11) - Cutoff curve
(12) - Roll
0.8 - 0.9 mm
⑩
⑪
⑫
⑧
⑨
Initial position: 43.7 mm