DURKOPP ADLER 969 Classic, Service Instructions Manual

Page: 35 / 122

Setting the drive
Service Instructions 969 - 06.0 - 03/2019 33
6.3 Setting the positioning of the machine
The machine will stop automatically at two angular positions on the main
shaft (of the handwheel). To ensure that the machine stops properly at
these positions, you need to set the reference position for the handwheel.
In order to ensure that the reference position is set properly, the drive ratio
between motor and main shaft must be entered correctly into the control
program of the machine.
6.3.1 Importing the drive ratio into the control program
Fig. 21: Importing the drive ratio into the control program
To import the drive ratio into the control program:
1. Select parameter setting mode on the OP1000 control panel (1)
and set the parameter t 08 19 (

Instructions for use DAC basic/
classic
).
2. Manually rotate the handwheel (2) by at least 2 turns.
 The display on the control panel will show a new value for the drive
ratio.
3. Press the OK button to confirm this new parameter value.
(1) - Control panel OP1000 (2) - Handwheel
②
①