DURKOPP ADLER 669 CLASSIC, Operating Instructions Manual

Page: 98 / 118

Setup
96 Operating Instructions 669 - 00.0 - 08/2019
6.13.5 Connecting the DC positioning drive to the
mains voltage
Important
A pluggable connection must be used to connect the sewing
machine to the mains supply voltage.
Information
The DC positioning drive is run with single-phase AC current of
190 - 240V 50/60Hz. The connection should be made according
to the
connection diagram 9800 120009 A or 9800 130014 R.
When connecting to a three-phase supply of 3x380V, 3x400V or
3x415V, the sewing drive should be connected to one phase and
to a neutral conductor.
When connecting to a three-phase supply of 3x200V, 3x220V,
3x230V or 3x240V, the sewing drive should be connected to two
of the phases.
If multiple DC positioning drives need to be connected to the same
three-phase supply, you should distribute the connections
amongst all of the phases equally so that no single phase is
overloaded.
Connecting the machine head
To connect the machine head:
1. The cable 9870 867000 is plugged into the head distributor
9850 867000. This cable is then routed downwards inside the
head
2. The 37-pole plug on the cable should be connected and
screwed in to socket A on the sewing drive.