DuraTech Industries Haybuster 572, Operating Instructions And Parts Reference, Page: 48 / 160

38 5 7 2 R O U N D B A L E R O P E R A T I N G I N S T R U C T I O N S
5.4.8 Twine Dispensing Indicators
Twine indicators are illuminated when the twine is being fed in to the baler. They will blink with an audible alarm
when they are not spinning during a tie sequence. For example, twine ball goes empty during tying sequence, this will
notify the operator.
5.4.9 Twine Arms Position Indicator
The twine arms position indicator is displayed on the Plus 1 controller across the top of the display. As the screen
indicator moves from left to right, this corresponds to the twine arm moving from center to right across the baler as
viewed from the rear of the machine.
5.4.10 Auto Dump Feature
The auto dump feature allows the operator to dump the bale automatically after a wrapping sequence is complete. The
feature can be turned on and off using the miscellaneous setup screen.
5.4.11 Faults Screen
This screen displays all system faults for the inputs and
outputs. An active fault is identified by a square box to the
left of the fault name. A fault is typically caused by poor
wire connections, faulty sensors or output coils. Faults are
indicated on the bale monitor screen by an exclamation
point by button 6.
5.4.12 Bale History
This screen displays bale counts for the current field,
current season, machine total bales, field hours and
machine total hours. The operator is able to edit or reset the
bales for the season and field but not the total bales. The
operator is also able to edit the field hours but not the total
hours.