DuraTech Industries Haybuster 572, Operating Instructions And Parts Reference, Page: 31 / 160

21
5 7 2 R O U N D B A L E R O P E R A T I N G I N S T R U C T I O N S
3.3.4 Wheel Nut Torque (lug bolts)
Wheel nuts need to have a torque minimum of 120 ft.‑lbs.
3.3.5 Tires and rims
Tires should be inflated to 25 PSI and should be free of cuts or cracks. There should also be adequate tread and no
visible cords, wires or tread separation. Tires must also be of proper load rating. Speed rating and size.
Rims must be free of cracks and rust pitting. Lug bolts must also be tight (minimum torque of 120 ft.‑lbs.) Inspect the
area around the lug bolts. If rust develops this is a sign of loose lug bolts.
Check wheel bearings and seals, replace and grease yearly.
3.4 Crop Preparation and Windrow Preparation
In preparing a crop for baling, consider the following to maximize the performance of the 572 Round Baler:
1. Make windrows slightly narrower than the width of the baler. This will enhance the feeding and prevent
plugging of windrows that are wider than the throat of the baler. OR make windrows up to one half the
width of the baler pickup and weave from left to right to form the bale.
2. Wait for the hay moisture content to be 20% or drier before baling.
3.5 To avoid plugging the baler
1. To help avoid plugging the baler, remove all obstruction such as sticks, stones, metal objects, etc. prior to
baling.
2. Match speed with crop conditions and windrow size.
3. Keep the baler properly adjusted at all times.
4. Keep gauge wheels adjusted so the pickup won’t hit the ground. (see Section 4.4) This will cause damage
to the pickup teeth and could dislodge stones and other materials.
3.6 Unplugging the baler
WARNING: Use normal shut down procedure (Section 3.1) before unplugging the baler. Serious
injuries will occur if you do not follow the procedure.
DANGER:
Engage tailgate lock and install cylinder stop before working on or around baler with
tailgate in raised position.