DuraTech Industries Haybuster 572, Operating Instructions And Parts Reference, Page: 32 / 160

22 5 7 2 R O U N D B A L E R O P E R A T I N G I N S T R U C T I O N S
3.7 Road Transport
3.7.1 Preparing baler for transport
1. Empty bale chamber.
2. Close tailgate completely
3. Raise pickup fully.
4. Clean SMV, reflectors, warning lights and make sure they operate with the tractor.
5. Check that safety chain is attached to the drawbar of the tractor or towing vehicle.
6. If transporting with another vehicle, remove PTO driveline assembly and secure machine half of PTO to
hitch of baler.
3.8 Unhitching from the tractor
CAUTION: Park the baler on level ground and block the wheels to prevent it from rolling.
To disconnect the 572 Round Baler from the tractor, preform the following steps:
1. Park the 572 Round Baler and tractor on a level spot.
2. Lower the jack to the ground, place blocks under jack if ground is soft.
3. Cycle the hydraulic controls to release any pressure in the hydraulic hoses. Disconnect hydraulic lines.
4. Disconnect electrical wires.
5. Disconnect PTO, place shaft in shaft holder.
6. Raise the hitch of the 572 Round Baler to remove the weight from the tractor hitch by adjusting the jack.
7. Remove hitch pin and safety chains. Place block under tires to prevent the baler from rolling.
8. Drive tractor away slowly.