DuraTech Industries Haybuster 572, Operating Instructions And Parts Reference, Page: 26 / 160

16 5 7 2 R O U N D B A L E R O P E R A T I N G I N S T R U C T I O N S
Section 3: Baler Operation
When operating the 572 Round Baler make sure that everyone is clear and/or at a safe distance from
the tractor and baler. No one other than the operator should ride the tractor or baler. NO RIDERS!
3.1 Normal shutdown procedure
For your safety and the safety of others, you must use the following normal shut‑down procedure before leaving the
tractor controls unattended for any reason, including servicing, cleaning, or inspecting the 572 Round Baler. A variation
of the following procedure may be used if so instructed within this manual or your tractor manual or if an extreme
emergency requires it.
a. Disengage PTO
b. Lower tailgate and pickup to ground.
c. Place transmission in park and set brake.
d. Shut off engine and remove key.
e. Wait for all movement to stop.
3.2 Tractor Setup
A tractor drawbar and 3 point arms can cause interference with the PTO driveline. This interference can cause serious
damage to the guarding and the telescoping members of the driveline.
If this implement is attached to a tractor with a clevis hitch style drawbar, the hammer-strap must be removed to prevent
damage to the guarding and telescoping members of the driveline.
If this implement is attached to a tractor with an offset drawbar, be certain it is in the down position to prevent damage
to the guarding and telescoping members. If this implement is attached to a tractor with a 3 point hitch, the arms must
be fully raised and locked in position.
3.2.1 Drawbar Adjustment
The distance from the end of the PTO to the center of the drawbar pin hole should be 16”, and the height from the top
of drawbar to centerline of the PTO should be 8”.
Figure 3.1
Safe P.T.O. distance